Ceiling tiles are a wonderful way to replace a roof and to brighten a room. The installing process is fast and relatively easy. If you are redecorating an old residential or commercial building to first decorate with ceiling tiles. It is a good choice to install in office or living rooms with irregular walls and/or roofs.
Prepare to Install
Measure complete opposite walls of your home in inches wide and extra add 12 inches then divided this number by two. The number you appear at is the width of the edge tile and Write down it. Repeat the process for the other rest walls.
Buy the ceiling tiles that usually come in 12x12 inch squares size or 12x24 inch rectangles size. Buy your Suspended Ceiling Tiles with leading supplier while you are at the United State. Decide which way the roof joists run. Fingernail the first furring remove perpendicular to the joists combined one wall then put two eight penny fingernails into the furring line at each joist but the ends of the furring line together to make a line along one wall. Make sure the furring pieces are level. Place shims between the furring space and the roof if necessary.
Nail the upcoming furring strip 12 inches on centre similar to the first furring strip. Proceed this process until you come to the reverse wall. Nail a furring strip equivalent to that wall as well. Install the boxes of ceiling tiles in the office or room at least 24 hours properly before you begin to ceiling tiles set up. This provides them a opportunity to adapt to the room.
Install the Ceiling Tiles
Start the work from one corner of room or office and cut the edge border piece to fit or Square it. Marking the beginning square on the furring piece. Make it sure the flanged edges and point toward the center of the room. You can use a staple gun to connect the corner ceiling tile. Put up the next ceiling tile along the border strip and staple it in place carefully. Now you can place a ceiling tile on the other frame of the area and again staple it. Just set the first full ceiling tiles in specified place. But it in place next area to the next three ceiling tiles that already in place.
Continue to perform from both sides of the area and out into the office or room. Protect the entire roof with diffrent ceiling tiles. Nail the last row of ceiling tile straight to the furring strip, if the staple gun doesn't appear into that tight of a spot. Measure and cut the molding strips to fit and Stain the strips. Use the miter box and saw to miter the corner pieces. Use the completing nails to nail the creating into place.
For more information about Ceiling Tiles, please visit: Newceilingtiles.com
No comments:
Post a Comment